No product dispensing

Not in AUTO mode. Select AUTO and allow machine to cycle off before drawing product.

More info

Low on mix. Add mix to the mix hopper. Fill the hopper to the proper level as shown in image.

More info

Feed tube not installed. Verify that the feed tube and check ring are installed.

Wear plastic gloves when preforming this procedure. Verify feed tube (A) and check ring (B) are installed.

More info

Possible cause: Pump motor is not running. Push the pump reset button. Check pump motor is operating when the draw valve is raised.

More info

Inspect assembly of the air/mix pump. Refer to operator’s manual for instructions.

Note: This will take approximately 15 minutes.

Verify there is a minimum of 3” (76 mm) of air space on all sides of the unit

If the step above does not resolve the issue, call for service.